Pg/Pc → Converter - Siemens SINAMICS G115D Operating Instructions Manual

Distributed drive for conveyor applications

Hide thumbs Also See for SINAMICS G115D:

Table of Contents

PG/PC → converter

You can transfer parameter settings from a PG/PC to the converter by the following method:

• Transfer with Startdrive

• Transfer with SINAMICS G120 Smart Access

Transferring using Startdrive

Precondition

• Connection between the PG/PC and converter has been properly established via a USB cable

or the fieldbus.

• You have installed the Startdrive commissioning tool on your PG/PC.

The procedure depends on whether you also transfer settings of safety functions or not.

Procedure with Startdrive without enabled safety functions

1. Go online.

2. Proceed as follows to transfer settings from the PG/PC to the converter:

3. Wait until Startdrive prompts that the transfer procedure is complete.

4. Go offline.

You have transferred the settings from the PG/PC to the converter with Startdrive.

Procedure with Startdrive when the safety functions are enabled

SINAMICS G115D Wall Mounted distributed drive

Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA

Data backup and series commissioning

8.2 Transferring settings using a PG/PC