7.2
Transferring settings using a PG/PC
7.2.1
Converter → PG/PC
You can transfer parameter settings from the converter to a PG/PC by the following method:
• Transfer with Startdrive
Transferring using Startdrive
Precondition
• Connection between the PG/PC and converter has been properly established via a USB
cable or the fieldbus.
• You have installed the Startdrive commissioning tool on your PG/PC.
Converter → PC/PG
1. Make sure that the converter is offline with Startdrive.
2. Proceed as follows to transfer settings from the converter to the PG/PC:
3. Wait until Startdrive prompts that the transfer procedure is complete.
You have transferred the settings from the converter to the PG/PC with Startdrive.
❒
SINAMICS G115D distributed drive
Operating Instructions, 09/2020, FW V4.7 SP13, A5E48681219B
Data backup and series commissioning
7.2 Transferring settings using a PG/PC
287