Siemens SINAMICS G115D Operating Instructions Manual page 63

Distributed drive for conveyor applications

Hide thumbs Also See for SINAMICS G115D:

Table of Contents

The Electronic Module is available in PROFINET variant, AS-i variant, and I/O Control (without

fieldbus communication) variant. The Wiring Module is available in glanded variant and

connector variant.

Depending on the variant ordered, the converter is equipped with plug-in sockets and/or

blanking caps (for wiring with cable glands).

For the connector variant, the converter is all wired up internally when delivered and all that

is required is the external wiring of the system. For the glanded variant, make sure you wire

the terminals and route the cables inside the Wiring Module and fix with the cable glands.

Note that the converters of glanded variant provide no cable glands but blanking caps at

delivery for all glanded interfaces.

Wall-mounted converter

The figure below shows an example of PROFINET variant of the wall-mounted converter with

plug-in sockets:

SINAMICS G115D Wall Mounted distributed drive

Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA

5.7 Overview of the converter interfaces