Advanced Settings - Siemens SINAMICS G115D Operating Instructions Manual

Parameters
Encoderless speed control
Parameter
p0342[0...n]
p1452[0...n]
p1470[0...n]
p1472[0...n]
p1496[0...n]
7.20.3.3

Advanced settings

K and T adaptation
P I
K and T
p
measurement" of the motor data identification optimizes the speed controller. If you have
performed the rotating measurement, then the K
You can find additional information in the List Manual:
• Vector control with speed controller: Function diagram 6050
Droop
For mechanically coupled drives, there is the risk that the drives oppose one another: Small
deviations in the speed setpoint or actual value of the coupled drives can mean that the drives
are operated with significantly different torques.
The droop function ensures even torque distribution between several mechanically coupled
drives.
The droop function reduces the speed setpoint as a function of the torque setpoint.
SINAMICS G115D Wall Mounted distributed drive
Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA
Description
Ratio between the total and motor
moment of inertia
Speed controller actual speed val‐
ue smoothing time (encoderless)
[ms]
Speed controller encoderless oper‐
ation P gain
Speed controller encoderless oper‐
ation integral time [ms]
Acceleration precontrol scaling [%] Sets the scaling for the acceleration precontrol of
adaptation suppress speed control oscillations that may occur. The "rotating
I
Advanced commissioning
Setting
Sets the ratio of moment of inertia load + motor to
moment of inertia of motor without load.
Factory setting: 1
Sets the smoothing time for the actual speed of the
speed controller for encoderless closed-loop speed
control.
Factory setting: 10
Sets the P gain for encoderless operation for the
speed controller.
Factory setting: 0.3
Set the integral time for encoderless operation for
the speed controller.
Factory setting: 20
the speed/velocity controller.
Factory setting: 0
- and T adaptation has been set.
p n
7.20 Motor control
293