Siemens SINAMICS G115D Operating Instructions Manual page 491

Distributed drive for conveyor applications

Hide thumbs Also See for SINAMICS G115D:

Table of Contents

Use a fitting device to fit the input or output elements.

Figure 12-16

Observe the correct mounting arrangement to minimize stress on shafts and bearings due to

lateral forces.

Figure 12-17

1. Use benzine or a solvent to remove the anti-corrosion protection from the shaft ends and

flanges. Or remove the existing protective skin.

2. Fit the drive input and output elements to the shafts. Lock the elements.

You have now attached the input or output element.

SINAMICS G115D Wall Mounted distributed drive

Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA

Example of a fitting device

Mounting arrangement for low stress on shafts and bearings

Additional information on the SIMOGEAR geared motor

12.3 Specific data gearbox