Changing the number of command data sets
1. Set p0010 = 15.
2. The number of command data sets is configured with p0170.
3. Set p0010 = 0.
You have changed the number of command data sets.
❒
Copying command data sets
1. Set p0809[0] to the number of the command data set whose settings you wish to copy
(source).
2. Set p0809[1] to the number of the command data set in which you wish to copy the settings.
3. Set p0809[2] = 1 to start the copying.
4. The converter sets p0809[2] = 0 after the copying finishes.
You have copied the settings of a command data set into another command data set.
❒
Example
As in the example above, you obtain the interconnection if you configured the interfaces of
the converter accordingly.
SINAMICS G115D Wall Mounted distributed drive
Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA
7.10 Switching over the drive control (command data set)
Advanced commissioning
223