If you have not only selected motor data identification with the motor stationary, but also
rotating measurement with self-optimization of the speed control, you must switch on the
motor again as described above and wait for the optimization run to finish.
Quick commissioning has been completed once the motor data identification has been
successfully completed.
6.4.3
Quick commissioning with the SINAMICS G120 Smart Access
You can access the SINAMICS G120 Web pages from a PC or a mobile device that connects to the
SINAMICS G120 Smart Access. The Web pages allow you to configure a comprehensive range of
settings to meet the specific requirements of the G115D converters. You can perform the
following three setups:
• Quick setup
• Application setup
• Safety setup
Further information
For more information on accessing the SINAMICS G120 Web pages and carrying out quick
commissioning, see the SINAMICS G120 Smart Access Operating Instructions.
SINAMICS G115D Wall Mounted distributed drive
Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA
Overview of the manuals (Page 588)
Commissioning
6.4 Quick commissioning
123