Connecting The Converter To Ethernet/Ip; What Do You Need For Communication Via Ethernet/Ip - Siemens SINAMICS G115D Operating Instructions Manual

Wiring
5.13 Connecting to PROFINET and Ethernet
You have now installed the GSDML in the engineering system of the controller.
❒
5.13.7

Connecting the converter to Ethernet/IP

Overview
To connect the converter to a control system via Ethernet, proceed as follows:
Procedure
1. Connect the converter to the control system via an Ethernet cable.
2. Create an object for data exchange.
You have the following options:
– Load the EDS file into your controller if you want to use the ODVA profile.
– If your controller does not accept the EDS file, or if you wish to use the SINAMICS profile,
You have connected the converter to the control system via Ethernet/IP.
❒
Example
You can find an example showing how to connect a converter to the control system via
Ethernet/IP on the Internet:
Further information
You can find information on routing and shielding Ethernet cables on the Internet:
PUB00035R0_Infrastructure_Guide.pdf)
5.13.8

What do you need for communication via Ethernet/IP?

Check the communication settings using the following questions. If you answer "Yes" to the
questions, you have correctly set the communication settings and can control the converter via
the fieldbus.
• Is the converter correctly connected to the Ethernet/IP?
• Is the EDS file installed in your control system?
94
You can find the EDS file on the Internet:
EDS (https://support.industry.siemens.com/cs/ww/en/view/78026217)
you must create a generic module in your controller:
Creating generic I/O module (Page 172)
Application example (https://support.industry.siemens.com/cs/ww/en/view/82843076)
Ethernet/IP (https://www.odva.org/wp-content/uploads/2020/05/
SINAMICS G115D Wall Mounted distributed drive
Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA