Transferring Settings Using A Pg/Pc; Converter → Pg/Pc - Siemens SINAMICS G115D Operating Instructions Manual
Distributed drive for conveyor technology control
Hide thumbs
Also See for SINAMICS G115D:
- Operating instructions manual (522 pages) ,
- Operating instructions manual (600 pages)
Table of Contents
Advertisement
7.2
Transferring settings using a PG/PC
7.2.1
Converter → PG/PC
You can transfer parameter settings from the converter to a PG/PC by the following method:
• Transfer with Startdrive
• Transfer with SINAMICS G120 Smart Access
Transferring using Startdrive
Precondition
• Connection between the PG/PC and converter has been properly established via a USB
cable or the fieldbus.
• You have installed the Startdrive commissioning tool on your PG/PC.
Converter → PC/PG
1. Make sure that the converter is offline with Startdrive.
2. Proceed as follows to transfer settings from the converter to the PG/PC:
3. Wait until Startdrive prompts that the transfer procedure is complete.
You have transferred the settings from the converter to the PG/PC with Startdrive.
❒
Transferring using SINAMICS G120 Smart Access
You can use the SINAMICS G120 Smart Access to transfer settings. For more information on
the transferring process, see Section "Backup and restore" in the SINAMICS G120 Smart
Access Operating Instructions.
SINAMICS G115D distributed drive
Operating Instructions, 12/2020, FW V4.7 SP13, A5E48681219B-002
Overview of the manuals (Page 542)
Data backup and series commissioning
7.2 Transferring settings using a PG/PC
311
Advertisement
Table of Contents
