Display Link-Aggregation Member-Port - HP E4510-48G Command Reference Manual

Bridge-Aggregation1 Load-Sharing Mode:
destination-mac address, source-mac address
# Display the link aggregation load sharing mode of each aggregation group.
<Sysname> display link-aggregation load-sharing mode interface
Bridge-Aggregation10 Load-Sharing Mode:
destination-ip address, source-ip address
Bridge-Aggregation20 Load-Sharing Mode:
Layer 2 traffic: destination-mac address, source-mac address
Layer 3 traffic: destination-ip address, source-ip address
Table 2-2 display link-aggregation load-sharing mode command output description
Link-Aggregation Load-Sharing Mode
Layer 2 traffic: destination-mac address,
source-mac address
Layer 3 traffic: destination-ip address,
source-ip address
destination-mac address, source-mac
address

display link-aggregation member-port

Syntax
display link-aggregation member-port [ interface-type interface-number [ to interface-type
interface-number ] ]
View
Any view
Default Level
1: Monitor level
Parameters
interface-type interface-number: Port type and port number.
to: Specifies an interface range in the form of interface-type interface-number to interface-type
interface-number, where the start interface number must be smaller than the end interface number.
Note that both the start interface and the end interface are inclusive.
Field Description
Displays the global link aggregation load sharing mode.
By default, the link aggregation load sharing modes
for Layer-2 traffic, and Layer-3 traffic displayed.
If you have configured a global load sharing mode,
the configured mode is displayed.
The default load sharing mode for Layer-2 traffic. In this
sample output, it is based on source MAC address and
destination MAC address.
The default load sharing mode for Layer-3 traffic. In this
sample output, it is based on source IP address and
destination IP address.
The user-configured link aggregation load sharing
mode. In this sample output, it is based on source MAC
address and destination MAC address.
2-4