Storm-Constrain Enable Trap; Storm-Constrain Interval - HP E4510-48G Command Reference Manual

Use the undo storm-constrain enable log command to disable log sending.
By default, log sending is enabled.
Examples
# Disable log sending for GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] undo storm-constrain enable log

storm-constrain enable trap

Syntax
storm-constrain enable trap
undo storm-constrain enable trap
View
Ethernet port view
Default Level
2: System level
Parameters
None
Description
Use the storm-constrain enable trap command to enable trap message sending. With trap message
sending enabled, the system sends trap messages when traffic reaching a port exceeds the
corresponding threshold or the traffic drops down below the lower threshold after exceeding the upper
threshold.
Use the undo storm-constrain enable trap command to disable trap message sending.
By default, trap message sending is enabled.
Examples
# Disable trap message sending for GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] undo storm-constrain enable trap

storm-constrain interval

Syntax
storm-constrain interval seconds
undo storm-constrain interval
View
System view
1-34