Qinq Commands; Display Qinq - HP 12500 Series Command Reference Manual

QinQ commands

This document uses the following terms:
CVLAN—Customer network VLANs, also called inner VLANs, refer to the VLANs that a
•
customer uses on the private network.
SVLAN—Service provider network VLANs, also called outer VLANs, refer to the VLANs that a
•
service provider uses to carry VLAN tagged traffic for customers.

display qinq

Use display qinq to display the QinQ-enabled interfaces.
Syntax
display qinq [ interface interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
interface interface-type interface-number: Displays whether QinQ is enabled on an interface
specified by its type and number. If no interface is specified, this command displays all
QinQ-enabled interfaces.
Usage guidelines
If QinQ is not enabled on any interface, this command does not provide any output.
Examples
# Enable QinQ on interface GigabitEthernet 3/0/1. Then verify whether QinQ is enabled on the
interface.
<Sysname> system-view
[Sysname] interface GigabitEthernet 3/0/1
[Sysname-GigabitEthernet3/0/1] qinq enable
[Sysname-GigabitEthernet3/0/1] display qinq interface GigabitEthernet 3/0/1
Interface
GigabitEthernet3/0/1
# Enable QinQ on interface GigabitEthernet 3/0/1 and GigabitEthernet 3/0/3. Then display all
QinQ-enabled interfaces.
<Sysname> system-view
[Sysname] interface GigabitEthernet 3/0/1
[Sysname-GigabitEthernet3/0/1] qinq enable
114