Qinq Vid (Available Only On The Hpe 3100 V2 Ei); Raw-Vlan-Id Inbound (Available Only On The Hpe 3100 V2 Ei) - HP 3100 v2 Series Command Reference Manual

Examples
# Set the TPID value in the VLAN tags to 0x8200.
<Sysname> system-view
[Sysname] qinq ethernet-type 8200

qinq vid (available only on the HPE 3100 v2 EI)

Syntax
qinq vid vlan-id
undo qinq vid vlan-id
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, port group view
Default level
2: System level
Parameters
vlan-id: Sets an outer VLAN ID, ranging from 1 to 4094.
Description
Use qinq vid to set the outer VLAN tag that the port adds to customer VLAN frames, and enter QinQ
view.
Use undo qinq vid to remove all configurations corresponding to the outer VLAN ID performed in
QinQ view.
By default, the outer VLAN tag is the port's PVID tag.
Configured in Layer 2 Ethernet interface view, the command takes effect on the interface only.
Configured in Layer 2 aggregate interface view, the command takes effect on the Layer 2 aggregate
interface and all the member ports in the aggregation group. Configured in port group view, the
command takes effect on all ports in the port group.
Related command: raw-vlan-id inbound.
Examples
# Configure selective QinQ on Ethernet 1/0/1 to tag frames with outer VLAN 10.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] qinq vid 10
# Configure selective QinQ on the ports in port group 1 to tag frames with outer VLAN 10.
<Sysname> system-view
[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member ethernet 1/0/1 to ethernet 1/0/6
[Sysname-port-group-manual-1] qinq vid 10

raw-vlan-id inbound (available only on the HPE 3100 v2 EI)

Syntax
raw-vlan-id inbound { all | vlan-list }
undo raw-vlan-id inbound { all | vlan-list }
184