Honda Accord 2008 Manual page 444

07/11/02 09:04:58 61TA0000_110_0125
DTC P0335:
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information (see page 11-3).
1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Start the engine.
4. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P0335 indicated?
YES
NO −
time. Check for poor connections or loose terminals
at the CKP sensor and the ECM/PCM.
5. Turn the ignition switch to LOCK (0).
6. Disconnect the CKP sensor 3P connector.
7. Turn the ignition switch to ON (II).
8. Measure voltage between CKP sensor 3P connector
terminal No. 3 and body ground.
＊０１
Is there battery voltage?
YES
−
NO
sensor and PGM-FI main relay 1, then go to step 19.
CKP Sensor No Signal
− Go to step 5.
Intermittent failure, the system is OK at this
CKP SENSOR 3P CONNECTOR
IGP (YEL/BLK)
Wire side of female terminals
− Go to step 9.
Repair open in the wire between the CKP
9. Measure voltage between CKP sensor 3P connector
terminal No. 1 and body ground.
CKP SENSOR 3P CONNECTOR
CKP (BLU)
Wire side of female terminals
Is there about 5 V ?
YES − Go to step 10.
−
NO Go to step 11.
10. Measure voltage between CKP sensor 3P connector
terminals No. 2 and No. 3.
CKP SENSOR 3P CONNECTOR
LG (BRN/YEL)
Wire side of female terminals
Is there battery voltage?
YES − Go to step 17.
−
NO Repair open in the wire between the CKP
sensor and G101 (see page 22-20), then go to step
19.
ＴＡ０８ＡＥＡＫ７２１０００９０３３５ＦＡＡＴ３０
IGP (YEL/BLK)
(cont'd)
11-125
＊０２
＊０３