07/11/02 09:04:59 61TA0000_110_0130
PGM-FI System
DTC Troubleshooting (cont'd)
12. Remove the ignition coil relay (A) from the under-
hood fuse/relay box.
*02
13. Disconnect all ignition coil 3P connectors.
14. Check for continuity between No. 1 ignition coil 3P
connector terminal No. 3 and body ground.
*03
Is there continuity?
YES
coils and the ignition coil relay. Also replace the
No. 13 IG COIL (15 A) fuse, then go to step 25.
NO
−
replace it if needed (see page 22-83), then go to
step 25.
11-130
A
No. 1 IGNITION COIL 3P CONNECTOR
+
B (BLK/WHT)
Wire side of female terminals
−
Repair short in the wire between the ignition
Check the under-hood fuse/relay box, and
15. Reinstall the ignition coil relay.
16. Disconnect the ignition coil 3P connector from the
problem cylinder.
17. Turn the ignition switch to ON (II).
18. Measure voltage between ignition coil 3P
connector terminal No. 3 of the problem cylinder
and body ground (see table).
PROBLEM
DTC
CYLINDER
No. 1
P0351
No. 2
P0352
No. 3
P0353
No. 4
P0354
IGNITION COIL 3P CONNECTOR
Wire side of female terminals
Is there battery voltage?
YES
−
Go to step 19.
NO
−
Repair open in the wire between the ignition
coil and the ignition coil relay, then go to step 25.
+
B (BLK/WHT)
*04