07/11/02 09:09:13 61TA0000_110_0171
13. Measure voltage between alternator 4P connector
terminal No. 4 and body ground.
*02
Is there about 5 V ?
YES
go to step 18.
NO
−
14. Turn the ignition switch to LOCK (0).
15. Jump the SCS line with the HDS.
16. Disconnect ECM/PCM connector B (49P).
ALTERNATOR 4P CONNECTOR
ALTF (WHT/RED)
Wire side of female terminals
−
Replace the alternator (see page 4-34), then
Go to step 14.
17. Check for continuity between alternator 4P
connector terminal No. 4 and ECM/PCM connector
terminal B47.
ALTERNATOR 4P CONNECTOR
ALTF (WHT/RED)
Wire side of female terminals
ECM/PCM CONNECTOR B (49P)
ALTF (WHT/RED)
Terminal side of female terminals
Is there continuity?
YES
−
Go to step 27.
NO
−
Repair open in the wire between the ECM/
PCM (B47) and the alternator, then go to step 18.
18. Turn the ignition switch to LOCK (0).
19. Reconnect all connectors.
20. Turn the ignition switch to ON (II).
21. Reset the ECM/PCM with the HDS.
22. Do the ECM/PCM idle learn procedure (see page
11-343).
23. Start the engine.
24. Check under these conditions:
• A/C on
• Temperature control at maximum cool
• Blower fan at maximum speed
• Rear window defogger on
• Headlights on high beam
*03
(cont'd)
11-171