Honda Accord 2008 Manual page 392

07/11/02 09:02:38 61TA0000_110_0073
8. Reconnect ECM/PCM connector B (49P).
9. Connect MAF sensor/IAT sensor 5P connector
terminals No. 1 and No. 2 with a jumper wire.
＊０２
＋
VG
10. Turn the ignition switch to ON (II).
11. Clear the DTC with the HDS.
12. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P0103 indicated?
YES
NO −
13. Turn the ignition switch to LOCK (0).
14. Replace the MAF sensor/IAT sensor (see page
11-227).
15. Reconnect all connectors.
16. Turn the ignition switch to ON (II).
17. Reset the ECM/PCM with the HDS.
18. Do the ECM/PCM idle learn procedure (see page
11-343).
MAF SENSOR/IAT SENSOR 5P CONNECTOR
−
(RED/BLK) VG (BLK/BLU)
JUMPER WIRE
Wire side of female terminals
−
Go to step 20.
Go to step 13.
19. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P0103 indicated?
YES − Check for poor connections or loose
terminals at the MAF sensor/IAT sensor and the
ECM/PCM, then go to step 1.
−
NO Troubleshooting is complete. If any other
Temporary DTCs or DTCs are indicated, go to the
indicated DTC's troubleshooting.
20. Turn the ignition switch to LOCK (0).
21. Reconnect all connectors.
22. Update the ECM/PCM if it does not have the latest
software (see page 11-231), or substitute a known-
good ECM/PCM (see page 11-7).
23. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P0103 indicated?
YES − Check for poor connections or loose
terminals at the MAF sensor/IAT sensor and the
ECM/PCM. If the ECM/PCM was updated, substitute
a known-good ECM/PCM (see page 11-7), then
recheck. If the ECM/PCM was substituted, go to
step 1.
NO − If the ECM/PCM was updated, troubleshooting
is complete. If the ECM/PCM was substituted,
replace the original ECM/PCM (see page 11-232). If
any other Temporary DTCs or DTCs are indicated,
go to the indicated DTC's troubleshooting.
11-73