07/11/02 09:10:58 61TA0000_110_0211
25. Measure voltage between DLC terminals No. 4 and
No. 16.
*04
Is there battery voltage?
YES
−
NO
No. 4 and body ground (G502) (see page 22-34).
26. Connect the HDS to the DLC (see page 11-3).
27. Jump the SCS line with the HDS.
28. Disconnect ECM/PCM connector A (49P).
29. Disconnect the HDS from the DLC.
DATA LINK CONNECTOR (DLC)
GND (BLK)
+
B (WHT)
Terminal side of female terminals
−
Go to step 26.
Repair open in the wire between DLC terminal
30. Connect DLC terminal No. 6 to body ground with a
jumper wire.
DATA LINK CONNECTOR (DLC)
CANH (WHT)
Terminal side of female terminals
31. Check for continuity between ECM/PCM connector
terminal A3 and body ground.
ECM/PCM CONNECTOR A (49P)
CANH (WHT)
Terminal side of female terminals
Is there continuity?
YES
−
Go to step 32.
−
NO
Repair open in the wire between the ECM/
PCM (A3) and DLC terminal No. 6.
JUMPER WIRE
I s
(cont'd)
11-211
*05
*06