Honda Accord 2008 Manual page 445

07/11/02 09:04:58 61TA0000_110_0126
PGM-FI System
DTC Troubleshooting (cont'd)
11. Turn the ignition switch to LOCK (0).
12. Jump the SCS line with the HDS.
13. Disconnect ECM/PCM connector C (49P).
14. Check for continuity between ECM/PCM connector
terminal C32 and body ground.
＊０４
Is there continuity?
YES
PCM (C32) and the CKP sensor, then go to step 19.
NO −
15. Connect CKP sensor 3P connector terminal No. 1 to
body ground with a jumper wire.
＊０５
11-126
ECM/PCM CONNECTOR C (49P)
CKP (BLU/YEL)
Terminal side of female terminals
− Repair short in the wire between the ECM/
Go to step 15.
CKP SENSOR 3P CONNECTOR
CKP (BLU)
JUMPER WIRE
Wire side of female terminals
16. Check for continuity between ECM/PCM connector
terminal C32 and body ground.
ECM/PCM CONNECTOR C (49P)
CKP (BLU/YEL)
Terminal side of female terminals
Is there continuity?
YES − Go to step 26.
−
NO Repair open in the wire between the ECM/
PCM (C32) and the CKP sensor, then go to step 19.
17. Turn the ignition switch to LOCK (0).
18. Replace the CKP sensor (see page 11-226).
19. Reconnect all connectors.
20. Turn the ignition switch to ON (II).
21. Reset the ECM/PCM with the HDS.
22. Clear the CKP pattern with the HDS.
23. Do the ECM/PCM idle learn procedure (see page
11-343).
24. Do the CKP pattern learn procedure (see page 11-5).
＊０６