Honda Accord 2008 Manual page 524

07/11/02 09:10:56 61TA0000_110_0205
42. Reconnect all connectors.
43. Connect the HDS to the DLC (see page 11-3).
44. Disconnect the gauge control module 32P
connector.
45. Turn the ignition switch to ON (II), and read the
HDS.
Does the HDS identif y the vehicle?
YES − Replace the gauge control module (see page
22-332).
−
NO Go to step 46.
46. Turn the ignition switch to LOCK (0).
47. Reconnect the gauge control module 32P connector.
48. Disconnect the VSA modulator-control unit 36P
connector.
49. Turn the ignition switch to ON (II), and read the
HDS.
Does the HDS identif y the vehicle?
YES − Replace the VSA control unit (see page
19-141).
−
NO Go to step 50.
50. Turn the ignition switch to LOCK (0).
51. Reconnect the VSA modulator-control unit 36P
connector.
52. Disconnect the yaw rate-lateral acceleration sensor
5P connector.
53. Turn the ignition switch to ON (II), and read the
HDS.
Does the HDS identif y the vehicle?
YES − Replace the yaw rate-lateral acceleration
sensor (see page 19-138).
−
NO Go to step 54.
54. Turn the ignition switch to LOCK (0).
55. Reconnect the yaw rate-lateral acceleration sensor
5P connector.
56. Disconnect SRS unit connector A (28P).
57. Turn the ignition switch to ON (II), and read the
HDS.
Does the HDS identif y the vehicle?
YES − Replace the SRS unit (see page 24-223).
NO − Go to step 58.
(cont'd)
11-205