Honda Accord 2008 Manual page 497

07/11/02 09:09:14 61TA0000_110_0178
PGM-FI System
DTC Troubleshooting (cont'd)
12. Turn the ignition switch to LOCK (0).
13. Jump the SCS line with the HDS.
14. Disconnect ECM/PCM connector A (49P).
15. Check for continuity between ECT sensor 2 2P
connector terminal No. 2 and ECM/PCM connector
terminal A10.
＊０３
Wire side of female terminals
Is there continuity?
YES
NO −
PCM (A10) and ECT sensor 2, then go to step 22.
11-178
ECT SENSOR 2 2P CONNECTOR
SG6 (BLK)
ECM/PCM CONNECTOR A (49P) SG6 (BLK)
Terminal side of female terminals
−
Go to step 27.
Repair open in the wire between the ECM/
16. Turn the ignition switch to LOCK (0).
17. Jump the SCS line with the HDS.
18. Disconnect ECM/PCM connector A (49P).
19. Check for continuity between ECT sensor 2 2P
connector terminal No. 1 and ECM/PCM connector
terminal A34.
ECT SENSOR 2 2P CONNECTOR
ECT2 (YEL/RED)
Wire side of female terminals
ECM/PCM CONNECTOR A (49P)
ECT2 (YEL/RED)
Terminal side of female terminals
Is there continuity?
YES − Go to step 27.
NO − Repair open in the wire between the ECM/
PCM (A34) and ECT sensor 2, then go to step 22.
＊０４