Honda Accord 2008 Manual page 396

07/11/02 09:02:40 61TA0000_110_0077
10. Turn the ignition switch to LOCK (0).
11. Jump the SCS line with the HDS.
12. Disconnect ECM/PCM connector C (49P).
13. Check for continuity between ECM/PCM connector
terminal C14 and MAP sensor 3P connector
terminal No. 3.
＊０３
Wire side of female terminals
ECM/PCM
CONNECTOR C (49P) SG1 (GRN/WHT)
Is there continuity?
YES
NO −
PCM (C14) and the MAP sensor, then go to step 20.
MAP SENSOR 3P CONNECTOR
SG1 (GRN/WHT)
Terminal side of female terminals
−
Go to step 25.
Repair open in the wire between the ECM/
14. Turn the ignition switch to LOCK (0).
15. Jump the SCS line with the HDS.
16. Disconnect ECM/PCM connector C (49P).
17. Check for continuity between ECM/PCM connector
terminal C11 and MAP sensor 3P connector
terminal No. 2.
MAP SENSOR 3P CONNECTOR
MAP (GRN/RED) Wire side of female terminals
MAP (GRN/RED) ECM/PCM CONNECTOR C (49P)
Terminal side of female terminals
Is there continuity?
−
YES Go to step 25.
NO − Repair open in the wire between the ECM/
PCM (C11) and the MAP sensor, then go to step 20.
＊０４
(cont'd)
11-77