07/11/02 09:10:09 61TA0000_110_0194
PGM-FI System
DTC Troubleshooting (cont'd)
12. Connect gauge control module 32P connector
terminal No. 29 to body ground with a jumper wire.
*03
13. Check for continuity between ECM/PCM connector
terminal A4 and body ground.
*04
Is there continuity?
YES
module (see page 22-332), then go to step 14 and
recheck. If DTC U0155 is not indicated after
substitution, replace the original gauge control
module (see page 22-332), then go to step 14.
NO
−
PCM (A4) and the gauge control module, then go to
step 14.
11-194
GAUGE CONTROL MODULE 32P CONNECTOR
Wire side of female terminals
ECM/PCM CONNECTOR A (49P)
CANL (RED)
Terminal side of female terminals
−
Substitute a known-good gauge control
Repair open in the wire between the ECM/
14. Reconnect all connectors.
15. Turn the ignition switch to ON (II).
16. Reset the ECM/PCM with the HDS.
17. Do the ECM/PCM idle learn procedure (see page
11-343).
CANL (RED)
18. Check for Temporary DTCs or DTCs with the HDS.
JUMPER WIRE
Is DT C U0155 indicated?
YES
−
terminals at the gauge control module and the
ECM/PCM, then go to step 1.
NO
−
Temporary DTCs or DTCs are indicated, go to the
indicated DTC's troubleshooting.
Check for poor connections or loose
Troubleshooting is complete. If any other