Honda Accord 2008 Manual page 450

07/11/02 09:05:00 61TA0000_110_0131
19. Turn the ignition switch to LOCK (0).
20. Check for continuity between ignition coil 3P
connector terminal No. 2 of the problem cylinder
and body ground (see table).
PROBLEM
CYLINDER
No. 1
No. 2
No. 3
No. 4
＊０５
Is there continuity?
YES
NO −
coil and G102, then go to step 25.
21. Jump the SCS line with the HDS.
22. Disconnect ECM/PCM connector C (49P).
DTC
P0351
P0352
P0353
P0354
IGNITION COIL 3P CONNECTOR
GND (BLK)
Wire side of female terminals
− Go to step 21.
Repair open in the wire between the ignition
23. Check for continuity between body ground and the
ECM/PCM connector terminal of the problem
cylinder (see table).
PROBLEM DTC ECM/PCM
CYLINDER TERMINAL
No. 1 P0351 C15
No. 2 P0352 C16
No. 3 P0353 C17
No. 4 P0354 C18
ECM/PCM CONNECTOR C (49P)
IGPLS2 (BLU/RED) IGPLS3 (WHT/BLU)
IGPLS1 (YEL/GRN)
Terminal side of female terminals
Is there continuity?
−
YES Repair short in the wire between the ECM/
PCM and the ignition coil, then go to step 25.
NO − Go to step 24.
WIRE
COLOR
YEL/GRN
BLU/RED
WHT/BLU
BRN
IGPLS4 (BRN)
(cont'd)
11-131
＊０６