Table of Contents
Advertisement
Configuring System-Wide Settings
Flex Configuration Settings
This section describes the required bridge settings for configuring Flex conference features.
See
Table 16
to configure Flex system settings.
Table 16: Flex Configuration Settings
System Administrator
Main Menu >
Configurations >
System Configuration
Configurations >
System Configuration
Configurations >
System Configuration
Configurations >
System Configuration
Configurations >
Voice Message
Configuration
Configure Scheduler
76 Administration and Maintenance of the S6200/S6800 Servers
Parameter / Setting
Moderator Lecture =
ON
Self Mute = ANYONE
Entry Tone = 1 beep or
2 beeps
Exit Tone = 1 beep or
2 beeps
Security Code Error
1&2 and Security Code
Error 3 = Tone or
Message, but not Both
On-Demand Pct.
To
Enable conference leaders to mute/
unmute non-leader line
Enable participants and moderators to
mute their lines.
Set the number of beeps in the entry tone
played to a conference when a
participant enters a conference
Set the number of beeps in the exit tone
played to a conference when a caller
exits a conference:
Enable security code error messages to
be played.
Note: When Security Code Error 1&2 is
set to TONE and an invalid code is
entered, then no message is played (only
the tone plays). The user may still enter a
correct Security Code. However, if on
any attempt, no security code is entered,
then the tone plays but the system does
not allow further attempts. The line is
either hung up or placed in the Enter
queue.
If Security Code Error 3 is set to TONE,
then only the tone is played and the line
is either hung up or placed in the Enter
queue.
Enable Flex calls to be scheduled. On
demand percentage must be at least 1 as
Flex calls use on demand ports.
1 of 3
Advertisement
Table of Contents
