Configuring The Nic - Avaya S8500 Replacing

Replacing the S8500 dual network interface
Figure 6: S8500 rear panel dual NIC LEDs
Figure notes:
Network activity LED
1.
(Tx/Rx)
Confirming original Ethernet configuration
After the media server is back in service, check the original Ethernet configuration settings:
1. Go to Server Configuration > Configure Server Web page.
2. Confirm that the server's Ethernet configuration settings are the same as before.

Configuring the NIC

To configure the new NIC:
1. At the Web interface select Server Configuration > Configure Server.
2. Click Continue through the review notices until you get to the xxx page.
3. Select Configure Individual Services and click Continue.
4. Select Set Identities and click Continue.
5. The following Ethernet ports are listed:
Control Network A: [default: Ethernet 0]
●
Services Port: [default: Ethernet 1]
●
Corporate LAN: [default: Ethernet 0]
●
10 Replacing the S8500 dual network interface
PCI
1
100-127 -, 3,0A, 50/60 Hz
200-240 -, 1,5A, 50/60 Hz PCI 2
133 MHz/64 Bit, 100 MHz/64 Bit
2
100-127 -, 3,0A,
200-240 -, 1,5A, 5
1
2.
Connection rate:
LED is off: there is a 10 BASE-T active link.
●
LED is green: there is a 100 BASE-T active link.
●
LED is orange: there is a 1000 BASE-T active link.
●
LINK TX/RX LINK TX/RX
1 2
h3msble2 KLC 082503