Assembling Clamp Bracket Parts; Installation Of Ptt Unit - TOHATSU TLDI MD 115A SERIES Service Manual

Cowl, Bracket and PTT

13) Assembling Clamp Bracket Parts

Install trim sensor 1 to clamp bracket.
1.
Install tilt stopper 2 and tilt stopper spring 9 to swivel bracket 8.
2.
Run swivel shaft 3 through clamp brackets, swivel bracket, bushing and washer, and tighten nylon nut 4 to
3.
specified torque.
Nylon Nut 4 :
25 N · m (18 lb · ft) [2.5 kgf · m]
Attach ground wire 5 and grease nipple 6.
4.
Attach anode 7.
5.

14) Installation of PTT Unit

Fully tilt up outboard motor and lock with tilt stopper 1.
1.
Check that tilt stopper lock the outboard
motor securely.
2. Retract tilt rod and trim rods.
3. Attach bushings to PTT (lower) and clamp bracket.
Install cylinder pin lower 2 and secure it with "C" ring 3.
4.
7-28
1
4
5
WARNING
1342
1342
6
OBM
5
8
6
OBM OBM
OBM
1
OBM OBM
OBM OBM
1342 1342
2
9
OBM OBM
OBM
3
6
OBM OBM
OBM
7
TLDI 115A 2007
OBM
1342
q