Removing Drive Shaft Housing - TOHATSU TLDI MD 115A SERIES Service Manual

Cowl, Bracket and PTT

5) Removing Drive Shaft Housing

Use the following steps to remove drive shaft housing.
1. Loosen and remove upper rubber mount cap installation
bolts to remove mount cap 1.
2. Loosen and remove upper rubber mount installation bolts
to remove rubber mount 2.
Loosen right and left rubber mount installation
bolts in several steps alternately and equally.
3. Loosen and remove lower rubber mount cap installation
bolts to remove mount cap 3.
4. Loosen lower rubber mount cap installation bolt and
remove the nut.
Fully tilt down outboard motor when loosening
mount bolt.
Remove only the nut and do not remove mount bolt.
Drive shaft housing drops if mount bolt is
removed in this step.
Pull out lower rubber mount bolt 3 while holding drive
5.
shaft housing at its top and bottom securely, and remove
drive shaft housing.
7-16
CAUTION
2
3
1
3
TLDI 115A 2007