Removing Drive Shaft Housing - TOHATSU MD 70-90C2 Service Manual

4. Remove pin and washer, then shift rod lever from shift rod.
5. Loosen and remove four bolts that secure bottom cowl to
engine base.
6. Remove bottom cowl.

4) Removing Drive Shaft Housing

Use the following steps to remove drive shaft housing.
1. Loosen and remove lower rubber mount cap installation
bolts to remove mount cap 1.
Remove grounding wire from gear case before
beginning the work.
2. Loosen lower rubber mount cap installation bolt and
remove the nut.
・Fully tilt down outboard motor when loosening
mount bolt.
・Remove only the nut and do not remove mount
bolt.
TLDI 75/90C2 2010
7
1
7-15