Removing The Power Unit - SELVA MARINE Pike 9,9 Service Manual

Removing the power unit

1. Disconnect the start-in-gear protection
cable, and then remove the driven
sprocket cover and manual starter. (M
model)
Remove the driven sprocket cover and
flywheel magnet cover. (E model)
2. Disconnect the battery cables 1, battery
lead 2, and starter motor lead 3. (E
model)
3 5
2
1
4
3. Disconnect the PT switch coupler 4, PT
switch lead (R) 5, and PT relay lead (G,
L) 6, and remove the PT relay 7. (PT
model)
6
4. Disconnect the engine shut-off switch
leads, oil pressure warning indicator
leads, and engine start button leads. (H
model)
Disconnect the 10-pin main harness from
the power unit. (R model)
6AU3K11
5
NOTE:
To disconnect the leads, see "Electrical com-
ponent and wiring harness routing" (8-1).
5. Disconnect the flushing hose 8 (for
Europe), cooling water hoses 9, and fuel
hose =.
1
0
6. Disconnect the throttle cables from the
throttle cam. (H model)
Disconnect the throttle cable joint from
the throttle cam. (R model)
7. Remove the choke rod, dipstick, and
S6AU5047
apron, and then remove the mounting
bolts A.
8. Remove the power unit B, gasket C,
and dowels D.
7
S6AU5048
Power unit
9
S6AU5046
B
D
C
A
A A S6AU5052
1
2
3
8
4
5
6
7
8
9
5-18