SELVA MARINE Pike 9,9 Service Manual page 131

7. Install the connecting rod caps D to the
connecting rods, and then tighten the
connecting rod cap bolts to the specified
torques in 2 stages.
E
D
È
NOTE:
• Make sure that the " " marks f on the
connecting rod cap face towards the fly-
wheel magnet end È of the crankshaft.
• Apply engine oil to the connecting rod cap
bolts before installation.
• After tightening the connecting rod cap
bolts, check that the crankshaft rotates
smoothly.
Connecting rod cap bolt:
1st: 6 N·m (0.6 kgf·m, 4.4 ft·lb)
2nd: 11 N·m (1.1 kgf·m, 8.1 ft·lb)
8. Install the remaining half of the main
bearings into the crankcase.
NOTE:
• Install the main bearings in their original
positions.
• Insert the projection of each bearing into
the slots in the crankcase.
9. Apply sealant to the mating surface of
the crankcase.
6AU3K11
f
E
S6AU5159
NOTE:
Do not get any sealant on the main bearings.
10. Install the crankcase onto the cylinder
block, and then tighten the crankcase
bolts to the specified torques in 2 stages
and in the sequence shown.
5
1
4
NOTE:
Apply engine oil to the threads of the crank-
case bolts before installation.
Crankcase bolt:
1st: 15 N·m (1.5 kgf·m, 11.1 ft·lb)
2nd: 30 N·m (3.0 kgf·m, 22.1 ft·lb)
Cylinder block
E
E
S6AU5160
6
2
E
3
S6AU5150
5-50
1
2
3
4
5
6
7
8
9