SELVA MARINE Pike 9,9 Service Manual page 173

6
5
a
7
Screwed-in length a:
8.0–9.0 mm (0.31–0.35 in)
5. Tighten the locknut 5.
NOTE:
After connecting the shift rod, check that the
gear shift operates properly.
6. Install the anode 8 and cooling water
inlet covers 9, and then tighten the
anode bolt to the specified torque.
9
9
Anode bolt:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
7. Install the propeller = and propeller nut
A. Place a block of wood between the
anti-cavitation plate and propeller to keep
the propeller from turning, and then
tighten the nut to the specified torque.
6AU3K11
Drive shaft and lower case (high thrust model)
S6AU6059
WARNING
• Do not hold the propeller with your
hands when loosening or tightening it.
• Be sure to disconnect the battery cables
from the battery and remove the clip
from the engine shut-off switch. (E
model)
NOTE:
8
If the holes in the propeller nut do not align
with the cotter pin hole, tighten the nut until
they are aligned.
LT LT
572
S6AU6138
8. Fill the lower unit with gear oil to the cor-
rect level.
D
D
Propeller nut:
21 N·m (2.1 kgf·m, 15.5 ft·lb)
Recommended gear oil:
Hypoid gear oil
API: GL-4
SAE: 90
Gear oil quantity:
3
370 cm
(12.51 US oz, 13.05 Imp oz)
0 A
1
2
S6AU6139
3
4
S6AU6062
5
6
7
8
9
6-38