Adjusting The Throttle Cable (R Model) - SELVA MARINE Pike 9,9 Service Manual

NOTE:
Be careful not to pull the outer cables too
much towards the power unit as they could
be pulled out of the holes in the pivot section
of the tiller handle. If the outer cables are
pulled out of the tiller handle, see "Installing
the tiller handle" (7-3) or "Installing the tiller
handle" (7-8).
5. Turn the adjusting nut 5 to remove the
slack in the throttle cable 7, and then
tighten the locknut 3.
6
a
7
6. Turn the throttle grip to the fully open and
fully closed positions and check that the
fully open stopper a and fully closed
stopper b on the throttle cam contact the
throttle cable bracket as shown. Repeat
steps 2–5 if necessary.
È
a
6AU3K11
2 4
3 5
S6AU3022
S6AU3059
Power unit / Control system
É
È Fully open position
É Fully closed position
7. Connect the throttle link rod 1 to the free
accel lever.
NOTE:
After adjusting the throttle cables, adjust the
throttle link.
Adjusting the throttle cable (R
model)
1. Disconnect the throttle link rod 1 from
the free accel lever.
2. Loosen the locknut 2, remove the clip
3, and then disconnect the throttle cable
joint 4.
1 6 5
3
4
2 7
3. Set the remote control lever to the N
position.
4. Check that the fully closed stopper a on
the throttle cam contacts the throttle
cable bracket 5.
1
b
2
S6AU3023
3
4
3
5
6
7
a
5
S6AU3024
8
9
3-8