SELVA MARINE Pike 9,9 Service Manual page 234

BRKT
3. Remove the reservoir cap 2, and then
check the fluid level in the reservoir.
NOTE:
• If the fluid is at the correct level, a small
amount of fluid should overflow out of the
filler hole.
• If fluid is below the correct level, add the
recommended PT fluid.
Recommended PT fluid:
ATF Dexron II
4. Install the reservoir cap 2, and then
tighten it to the specified torque.
Reservoir cap 2:
5 N·m (0.5 kgf·m, 3.7 ft·lb)
5. Connect the PT motor leads to the bat-
tery terminals to fully retract the tilt ram.
7-53
Bracket unit
Ram PT motor lead
Green (G)
Down
Blue (L)
6. Reverse the PT motor leads between the
battery terminals to fully extend the tilt
ram.
Ram PT motor lead
Blue (L)
Up
Green (G)
NOTE:
• Repeat steps 5–6 to fully extend and retract
the tilt ram 4 to 5 times.
• If the tilt ram does not move up and down
easily, push and pull on the ram to assist
the operation.
7. Fully extend the tilt ram.
8. Remove the reservoir cap, and then
check the fluid level in the reservoir.
WARNING
Make sure that the tilt ram is fully
extended when removing the reservoir
cap, otherwise fluid can spurt out from
the unit due to internal pressure.
Battery
terminal
+
-
Battery
terminal
+
-
6AU3K11