Installing The Shift Rod, Drive Shaft Housing, And Drive Shaft; Installing The Propeller Shaft Housing - SELVA MARINE Pike 9,9 Service Manual

LOWR
Installing the shift rod, drive shaft
housing, and drive shaft
1. Install the forward gear assembly 1 into
the lower case.
2. Install the drive shaft sleeve 2 into the
lower case.
NOTE:
Install the drive shaft sleeve 2 with the hole
a facing forward.
3. Install the shift rod 3, a new gasket 4,
and the drive shaft housing assembly 5.
NOTE:
Make sure that the projection b on the gas-
ket is toward the port side.
4. Install the drive shaft 6, original pinion
shim(s) 7, roller bearing 8, pinion 9,
and pinion nut = to the drive shaft.
5
4
a
3
6-35
Lower unit
6
b
2
G
7
8
G
9
0
1
G
S6AU6126
NOTE:
6 • When installing the pinion, lift up the drive
shaft slightly and align the pinion and shaft
splines.
• Be sure to select the pinion shim(s) if
replacing the pinion, roller bearing, or lower
case. To select the shim, see "Shimming
(high thrust model)" (6-39).
5. Tighten the pinion nut = to the specified
torque.
Pinion nut =:
25 N·m (2.5 kgf·m, 18.4 ft·lb)

Installing the propeller shaft housing

1. Install the propeller shaft assembly 1
into the lower case.
2. Install the washer 2 and propeller shaft
housing assembly 3 into the lower case,
and then tighten the bolts 4 to the speci-
fied torque.
S6AU6127
1
G
S6AG6341
6AU3K11
6