Installing The Clamp Bracket - SELVA MARINE Pike 9,9 Service Manual

NOTE:
• See the exploded diagram for the installa-
tion directions of the spring D and tilt lock
rod 1 E (7-27).
• Make sure that the E-clips are installed
securely.

Installing the clamp bracket

1. Install the tilt stopper plates 1 and tilt
stopper plate bolts 2 (clamp bracket
side) to the clamp brackets, and then
tighten the bolts to the specified torque.
Tilt stopper plate bolt 2:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
1
A
A A
5
C
B
0
7
A A
9
0
2. Tighten the self-locking nut 3 completely
onto the shorter threaded end of the
through tube 4.
a
4
a b
6AU3K11
7
2
2
1
A A
6
C
5
4
3
A A
8
D
LT
S6AU7046
242
A
b 3
A A
S6AG7801
Clamp bracket and swivel bracket (MT model)
3. Assemble the clamp brackets 5 and
swivel bracket 6, and then install the
collar 7, clamp bracket bolt 8, and
through tube 4 from the port side.
NOTE:
When installing the through tube 4, hook tilt
lock rod 1 9 onto the tilt lock lever 0.
4. Install the self-locking nut A onto the
through tube 4, and then tighten it to the
specified torque.
Self-locking nut A:
19 N·m (1.9 kgf·m, 14.0 ft·lb)
5. Tighten the clamp bracket nut B.
6. Install the tilt stopper plates 1 and tilt
stopper plate bolts C (swivel bracket
side) to the swivel bracket, and then
tighten the bolts to the specified torque.
Tilt stopper plate bolt C:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
7. Install the tilt pin D.
8. Apply grease to all grease nipples until it
comes out from the areas a.
A A
a
A A
NOTE:
To check the tilt operation, see "Checking the
tilt system (MT model)" (1-17).
a
S6AU7048
7-30
1
2
3
4
5
6
7
8
9