Installing The Upper Case - SELVA MARINE Pike 9,9 Service Manual

A A
1
A A
2
4. Apply grease to the grease nipple 7 on
the swivel bracket until it comes out from
the upper bushing a.
A A
NOTE:
To assemble the clamp brackets, see "Install-
ing the clamp bracket" (7-30) or "Installing the
clamp bracket" (7-34).

Installing the upper case

1. Install the upper case assembly 1 to the
clamp bracket.
2. Install the plate and upper mounting nuts
2, and then tighten the upper mounting
nuts to the specified torque.
3. Install the ground lead terminal 3 to the
upper case as shown.
4. Install the rubber dampers 4 and 5
(front), and then install the mount hous-
ings 6 and ground lead terminal 7
using the mount housing bolts 8 and 9
and the mount housing nuts 0.
6AU3K11
3
4
5
6
A A
S6AU7033
a
7
S6AG7740
7
Upper case and steering arm
NOTE:
Install the ground lead terminal 7 so that it is
within the range a (30°) shown.
5. Tighten the mount housing nuts 0 to the
specified torques in 3 stages and in the
sequence shown.
NOTE:
Tighten the mount housing nuts 0 evenly
and in the following order: 1–2–3–4.
6. Install the ground lead terminal A to the
swivel bracket.
7. Install the water pipe B.
A
C
6
0
0
5
BOW
C
1
a
2 7
A
B
2
1
4
4
6
9
3
7 8
S6AU7035
A
3
4
3
S6AU7036
7-24
1
2
3
4
5
6
7
8
9