SELVA MARINE Pike 9,9 Service Manual page 151

2. Set the shift rod to the R position.
F
N
R
3. Install the lower unit to the upper case,
and then tighten the lower case mounting
bolts 1 to the specified torque.
2
LT LT
572
NOTE:
• Before installing the lower unit to the upper
case, install the dowels 2 into the lower
case.
• Before installing the lower unit, make sure
that the locknut is removed from the shift
rod.
• When installing the lower unit, make sure
that the water pipe 3 is inserted securely
into the rubber seal 4.
Lower case mounting bolt 1:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
4. Install the locknut 5, and then screw the
adjusting nut 6 onto the shift rod 7.
6AU3K11
F
N
R
S6AU6057
2
3
4
1
S6AU6058
Drive shaft and lower case
6
5
a
7
Screwed-in length a:
8.0–9.0 mm (0.31–0.35 in)
5. Tighten the locknut 5.
NOTE:
After connecting the shift rod, check that the
gear shift operates properly.
6. Install the anode 8 and cooling water
inlet covers 9, and then tighten the
anode bolt to the specified torque.
9
9
Anode bolt:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
1
2
S6AU6059
3
4
5
6
8
7
LT LT
572
S6AU6060
8
9
6-16