Checking The Tilt Operation (Mt Model); Checking The Tilt Operation (Pt Model); Checking The Pt Fluid Level - SELVA MARINE Pike 9,9 Service Manual

CHK
ADJ
2. Adjust the self-locking nut 2 until the
steering operation is proper.
Checking the tilt operation (MT
model)
1. Fully tilt the outboard motor up and down
a few times and check the entire tilt
range for smooth operation. Check the tilt
mechanism if necessary.
NOTE:
To check the tilt operation, see "Checking the
tilt system (MT model)" (1-17).
Checking the tilt operation (PT
model)
1. Fully tilt the outboard motor up and down
a few times and check the entire tilt
range for smooth operation. Check the
PT fluid level if necessary.
NOTE:
• To check the PT fluid level, see "Checking
the PT fluid level" (3-13).
• Be sure to listen to the winding sound of the
PT motor for smooth operation.
2. Fully tilt the outboard motor up, and then
support it with the tilt stop lever to check
the lock mechanism of the lever.
3-13
Periodic check and adjustment
2
S6AG3430

Checking the PT fluid level

1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever.
3
WARNING
After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could sud-
denly lower if the PT unit should lose fluid
pressure.
2. Remove the reservoir cap 1, and then
check the fluid level in the reservoir.
3
1
NOTE:
If the fluid is at the correct level, a small
amount of fluid should overflow out of the
filler hole when the cap is removed.
3. If necessary, add sufficient fluid of the
recommended type until it overflows out
of the filler hole.
Recommended PT fluid:
ATF Dexron II
S6AG3220
3
S6AG3230
6AU3K11