Checking The Start-In-Gear Protection (M Model); Checking The Engine Idle Speed - SELVA MARINE Pike 9,9 Service Manual

CHK
ADJ
4. Adjust the position of the shift cable joint
until its hole is aligned with the set pin on
the shift rod lever joint.
WARNING
The shift cable joint must be screwed in a
minimum of 8.0 mm (0.31 in) a.
5. Connect the shift cable joint 3, install the
clip 2, and then tighten the locknut 1.
6. Adjust the shift rod adjusting nut 4.
4
NOTE:
To adjust the shift rod adjusting nut 4, see
"Installing the lower unit" (6-15) or "Installing
the lower unit" (6-37).
7. Check the gear shift for smooth opera-
tion.
Checking the start-in-gear protection
(M model)
CAUTION:
Be sure to remove the clip from the
engine shut-off switch before checking
the start-in-gear protection.
3-11
Periodic check and adjustment
a
S6AG3130
S6AU3033
1. Set the shift lever to the F position or R
position, and then check that the starter
handle cannot be pulled. If the starter
rope can be pulled out normally, adjust
the start-in-gear protection cable.
2. Set the shift lever to the N position and
loosen the locknut 1. Align the cable
end a with the mark b on the manual
starter cover by turning the adjusting nut
2.
3. Tighten the locknut 1.
2
1

Checking the engine idle speed

1. Start the engine and warm it up.
2. Attach the special service tool to spark
plug wire #1 1, and then check the
engine idle speed. Adjust if out of specifi-
cation.
3
a
b
S6AU3034
1
S6AU3035
6AU3K11
3