Adjusting The Throttle Link - SELVA MARINE Pike 9,9 Service Manual

CHK
ADJ
5. Adjust the position of the throttle cable
joint 4 until its hole is aligned with the
set pin on the throttle cam 6.
WARNING
The throttle cable joint must be screwed
in a minimum of 8.0 mm (0.31 in) b.
NOTE:
Pull the throttle cable 7 towards the engine
to remove any free play in the cable before
adjusting the position of the throttle cable
joint.
6. Connect the throttle cable joint 4, install
the clip 3, and then tighten the locknut
2.
7. Set the remote control lever to the fully
open and fully closed positions and
check that the fully open stopper c and
fully closed stopper a on the throttle
cam contact the throttle cable bracket as
shown.
È
c
3-9
Periodic check and adjustment
b
S6AG1090
S6AU3060
É
È Fully open position
É Fully closed position
8. Connect the throttle link rod 1 to the free
accel lever.
NOTE:
After adjusting the throttle cable, adjust the
throttle link.

Adjusting the throttle link

1. Loosen the throttle link stopper screw 1.
b
3
1
2. Turn the throttle grip (H model) or remote
control lever (R model) to the fully open
position and hold it in place. Check that
the fully open stopper 2 on the throttle
cam contacts the throttle cable bracket
a.
NOTE:
If the fully open stopper 2 does not contact
the throttle cable bracket a, adjust the throt-
tle cable(s). See "Adjusting the throttle cable
(H model)" (3-7) or "Adjusting the throttle
cable (R model)" (3-8).
3. Turn the carburetor throttle lever 3
clockwise so that it contacts the carbure-
tor body b as shown.
a
S6AU3026
4
2
a
c
S6AU3027
6AU3K11
3