Checking The Warning Indicator Assembly - SELVA MARINE Pike 9,9 Service Manual

– +
ELEC
4. Check the oil pressure switch 1 for con-
tinuity when the engine is stopped and
when it is running. Check the oil pressure
and oil pressure switch if out of specifica-
tion.
P P
Oil pressure switch continuity:
Oil pressure switch – Ground
Engine condition
Stopped
Running
5. Remove the oil pressure switch.
6. Connect the special service tool to the oil
pressure switch.
7. Check the oil pressure switch for continu-
ity at the specified pressures. Replace if
out of specification.
8-35
Electrical system
1
S6AU8048
Continuity
Yes
No
S6AG8130
NOTE:
Slowly operate the special service tool.
Vacuum/pressure pump gauge set:
90890-06756
Oil pressure switch continuity:
Oil pressure switch – Ground
Oil pressure
More than 14.7 kPa
2
(0.147 kgf/cm , 2.132 psi)
Less than 14.7kPa
2
(0.147 kgf/cm , 2.132 psi)
NOTE:
Apply pressure to the oil pressure switch
gradually. The oil pressure switch is operat-
ing correctly if the digital tester indication
changes from continuity to no continuity in
the range of 14.7 ± 4.9 kPa (0.147 ±
, 2.132 ± 0.711 psi).
2
0.049 kgf/cm
8. Install the oil pressure switch, and then
connect the oil pressure switch connec-
tor.
Checking the warning indicator
assembly
1. Disconnect the oil pressure switch con-
nector, and then ground the pink (P) lead
(wiring harness end).
2. Start the engine, increase the engine
speed to approximately 2,000 r/min, and
check that the oil pressure warning indi-
cator comes on.
3. Push the engine stop button. (H model)
Turn the engine start switch to "OFF." (R
model)
4. Connect the oil pressure switch lead ter-
minal.
5. Disconnect the warning indicator assem-
bly coupler.
Continuity
No
Yes
8
6AU3K11