Assembling The Manual Starter - SELVA MARINE Pike 9,9 Service Manual

POWR
3. Check the sheave drum. Replace if
cracked or damaged.
4. Check the spiral spring. Replace if
cracked, bent, or damaged.
5. Check the starter handle. Replace if
cracked or damaged.
6. Check the starter rope. Replace if dam-
aged.
NOTE:
• When replacing the starter rope with a new
one, make sure that the length is approxi-
mately 1,900 mm (74.8 in).
• Be sure to use a genuine Selva starter
rope.

Assembling the manual starter

1. Install the starter rope 1 into the sheave
drum 2.
2. Install the drive pawl 3, starter plunger
4, drive pawl spring 2 5, spring 6, and
E-clip.
3. Install the starter handle 7.
5-9
Power unit
S6AG5540
2 3
5
6
NOTE:
• Tie a knot at the end of the starter rope as
shown in the illustration.
• Be sure to leave 12–20 mm (0.47–0.79 in)
a at the end of the starter rope.
4. Wind the starter rope 1 twice around the
sheave drum 2 in the direction of the
arrow shown.
5
1
2
NOTE:
After winding the starter rope 1 around the
sheave drum 2, install the starter rope in the
notch b.
5. Install the spiral spring 8 into the manual
starter cover 9.
4
1
E
1
b
7
a
S6AU5030
1
2
S6AU5031
6AU3K11