Assembling The Propeller Shaft Housing - SELVA MARINE Pike 9,9 Service Manual

LOWR
Assembling the propeller shaft
housing
1. Install a new bushing into the propeller
shaft housing to the specified depth.
Driver rod L3 1: 90890-06652
Needle bearing attachment 2:
90890-06617
2. Apply grease to new oil seals, and then
install them into the propeller shaft hous-
ing to the specified depth a.
3
a
4
NOTE:
Install an oil seal halfway into the propeller
shaft housing, and then install the other oil
seal.
Driver rod L3 3: 90890-06652
Needle bearing attachment 4:
90890-06614
6-9
Lower unit
1
G
2
S6AU6021
A A
S6AU6023
Installation depth a:
6
3.0–3.5 mm (0.12–0.14 in)
3. Install a new ball bearing into the propel-
ler shaft housing.
NOTE:
Install the ball bearing with the manufacture
identification mark facing toward the reverse
gear.
Driver rod LS 5: 90890-06606
Ball bearing attachment 6:
90890-06634
4. Install the reverse gear and original
shim(s) into the propeller shaft housing.
G
NOTE:
After installing the reverse gear and shim(s),
check that the gear rotates smoothly.
5
6
G
S6AU6025
S6AU6026
6AU3K11