J
I
H
G
NOTE:
• Install the pinion stopper I in the direction
shown.
• Check the starter motor operation again
after assembling it.
Installing the starter motor
1. Install the starter motor to the power unit.
2. Connect the wiring harness to the starter
motor, and then fasten the wiring har-
ness.
NOTE:
To connect the wiring harness to the starter
motor, see "Electrical component and wiring
harness routing" (8-1).
Starting system
Checking the fuse (E model)
1. Check the fuse for continuity. Replace if
there is no continuity.
NOTE:
For the location of the fuse, see "Electrical
component and wiring harness routing" (8-1).
6AU3K11
Starter motor (E model) / Starting system
Checking the engine start button (H
J
model with electric starter)
1. Disconnect the engine start button 1
I
connectors.
H
2. Measure the input voltage between the
connector (wiring harness end) of the
G
engine start button 1 and the ground.
Check the fuse 2 and wiring harness if
S6AG8510
below specification.
8
8
8
S6AU8024
1
R
R
Br
R
Br
Br
Engine start button input voltage
(reference data):
Red (R) – Ground
12 V (battery voltage)
8
1
2
3
4
2
R
5
R
S6AU8025
6
7
8
9
8-26