SELVA MARINE Pike 9,9 Service Manual page 190

BRKT
4. Install the engine shut-off switch 5 to the
tiller handle 6, and then tighten the nut
7 to the specified torque. Pass the
engine shut-off switch lead through a
hole in the pivot section of the tiller han-
dle.
5. Install the PT switch 8 to the bracket 9,
and then tighten the bracket screws 0 to
the specified torque. (PT model)
6. Install the PT switch 8 to the tiller handle
6, and then tighten the PT switch
screws A and B to the specified torque.
(PT model)
7
B
0
9
8
NOTE:
Tighten the screws A, and then tighten the
screw B.
Engine shut-off switch nut 7:
2 N·m (0.2 kgf·m, 1.5 ft·lb)
PT switch bracket screw 0:
4 N·m (0.4 kgf·m, 3.0 ft·lb)
PT switch screw A and B:
6 N·m (0.6 kgf·m, 4.4 ft·lb)
7. Connect the throttle cable ends to the
throttle pulley C.
7-9
Bracket unit
6
A
5
S6AU7006
6
C
D
NOTE:
• When routing the engine shut-off switch
lead, make sure that it does not contact the
throttle shaft D in the area a.
• Make sure that the ends b of the outer
throttle cables E are fitted securely into the
holes in the pivot section of the tiller handle
as shown.
8. Install the tiller handle assembly to the
tiller handle bracket, and then tighten the
nuts to the specified torque.
Tiller handle assembly nut:
10 N·m (1.0 kgf·m, 7.4 ft·lb)
Tiller handle assembly self-locking
nut: 22 N·m (2.2 kgf·m, 16.2 ft·lb)
9. Install the tiller handle assembly to the
steering bracket, and then tighten the
nuts to the specified torque.
Tiller handle bracket nut:
36 N·m (3.6 kgf·m, 26.6 ft·lb)
10. Connect the throttle cables to the throttle
cam.
NOTE:
• To adjust the throttle cables, see "Adjusting
the throttle cable (H model)" (3-7).
• When adjusting the throttle cables, make
sure that the ends b of the outer cables
are not pulled out of the holes in the pivot
section of the tiller handle.
E
b
b
a
S6AU7007
6AU3K11