SELVA MARINE Pike 9,9 Service Manual page 128

POWR
2. Place the cylinder block upside down on
a bench.
3. Install half of the main bearings 1 and
the crankshaft 2 into the cylinder block
3.
NOTE:
• Install the main bearings in their original
positions.
• Insert the projection a of each bearing into
the slots in the cylinder block.
4. Put a piece of Plastigauge (PG-1) on
each crankshaft journal parallel to the
crankshaft.
NOTE:
Be sure not to put the Plastigauge (PG-1)
over the oil hole in each crankshaft journal.
5. Install the remaining half of the main
bearings into the crankcase.
NOTE:
• Install the main bearings in their original
positions.
• Insert the projection of each bearing into
the slots in the crankcase.
5-47
Power unit
6. Install the crankcase onto the cylinder
block.
NOTE:
Apply engine oil to the threads of the crank-
case bolts.
7. Tighten the crankcase bolts to the speci-
fied torques in 2 stages and in the
sequence shown.
5
1
4
NOTE:
Do not turn the crankshaft until the crankshaft
journal oil clearance measurement has been
completed.
Crankcase bolt:
1st: 15 N·m (1.5 kgf·m, 11.1 ft·lb)
2nd: 30 N·m (3.0 kgf·m, 22.1 ft·lb)
8. Gently remove the crankcase, and then
measure the width of the compressed
Plastigauge (PG-1) on each crankshaft
journal. Replace the main bearings if out
of specification.
6
2
E
3
S6AU5150
6AU3K11