SELVA MARINE Pike 9,9 Service Manual page 105

8. Align the notch e in the drive sprocket
with the " " mark f on the cylinder
block by turning the crankshaft counter-
clockwise approximately 90° gradually.
9. Install the timing belt D onto the drive
sprocket, and then install it onto the
driven sprocket with its part number g in
the upright position.
D
CAUTION:
• Do not twist, turn inside out, or bend the
timing belt beyond the maximum limit of
25 mm (1.0 in), otherwise it can be dam-
aged.
• Do not get oil or grease on the timing
belt.
10. Turn the drive sprocket clockwise 2
turns, and then check that the parts are
aligned at the areas h and k as shown.
6AU3K11
f
e
S6AU5068
g
S6AU5069
Timing belt and sprocket
k
D
11. Install the charge coil, lighting coil(s), and
flywheel magnet.
NOTE:
See "Replacing the timing belt" (5-3).
h
1
2
S6AU5070
3
4
5
6
7
8
9
5-24