SELVA MARINE Pike 9,9 Service Manual page 85

2
" mark a on the driven
6. Align the "1
sprocket 3 with the " " mark b on the
thermostat cover.
NOTE:
Check that the notch c in the drive sprocket
and the " " mark d on the cylinder block are
aligned.
7. Remove the timing belt 4 from the
driven sprocket, and then remove it from
the drive sprocket.
6AU3K11
4
S6AU5015
CAUTION:
Unless directed to do so in the following
instructions,
sprocket or driven sprocket when the tim-
ing belt is not installed. Otherwise the pis-
3
tons and valves will collide with each
other and be damaged.
a
8. Install a new timing belt 4 onto the drive
b
S6AU5016
d
4
c
S6AU5017
CAUTION:
• Do not twist, turn inside out, or bend the
timing belt beyond the maximum limit of
25 mm (1.0 in), otherwise it can be dam-
aged.
• Do not get oil or grease on the timing
belt.
NOTE:
Before installing the timing belt, make sure
that the notch on the drive sprocket and the
mark on the driven sprocket are aligned with
the marks on the cylinder block and thermo-
stat cover.
Power unit (check and adjustment)
do not turn
sprocket, and then install it onto the
driven sprocket with its part number e in
the upright position.
1
2
S6AU5018
3
the drive
4
5
e
6
7
S6AU5019
8
9
5-4