Trim Adjusting (With Power-Trim Device Unusable); Overheat Warning System - SELVA MARINE MADEIRA 40 Owner's Manual

Turn clockwise the trim release screw, that you can reach through the hole
on the left bracket.
Lift the motor by hand and fix it in this position pushing towards the high
the motor's supports and turning the trim release screw in counter
clockwise direction at the end of its stroke.
Lower it and accompany it while lowering it and secure it in this position
turning the trim release screw in counter clockwise direction.

Trim adjusting (with Power-Trim device unusable)

To adjust the trim when the Trim device is not operating, follow
these instructions.
If the motor is in tilt position (lifted) you have to:
•
Insert the trim-pin in that position that allows a correct trim.
•
Turn in a clockwise direction the trim release screw. (in this way
the pressure on the piston of the tilt will discharge and the motor is
no more supported) It must be accompanied till it's lowered.
•
When the motor leans on the adjustment pin you have to turn the
trim release screw in a counter clockwise direction till the end of
the stroke, paying attention not to force too much.
•
The motor is fixed in the correct trim position and it's possible to
cruise.
If the motor is in cruising position you need to follow the same operations
turning it over by hand.
Picture No. 56
If the motor is in tilt position, it begins to lower as soon as you turn the
release screw in a clockwise direction.

Overheat warning system

the engine becomes too hot, the engine speed fall suddenly (as a matter
of fact this device leaves out the connection of a ignition-coil)
If the overheat warning system operates, proceed as follows: Check that
water runs out of the pilot hole. If OK, keep the engine at low speed for
about five minutes. Then avoid overloading the engine. If no water or just a
little runs out from the pilot hole, stop the engine, tilt it up, as shown in this
manual and check the water inlets for blockages. If blocked, you must
clean them, bring the motor back to the home position and start it and run
it at low speed for about five minutes; check that water runs out of the pilot
hole.
If after having done all this, you start the engine and no water runs out of
the pilot hole, stop immediately the motor and contact a SELVA MARINE
dealer.
Picture No. 57
https://www.boat-manuals.com/
30
These operations must be made when the motor is off.
The engine is provided with an overheat warning device Before